Triumph Tiger Explorer XR 2016, Service Manual

Page: 426 / 750

Note
selected direction.
Click start and check for rear preload motor adjustment collar movement. A maximum of three attempts may
be made to free the motor from an end stop. The attempt to free the motor is successful if adjustment collar
movement is observed. 6.
Note
If after three attempts to free the motor no adjustment collar movement can be observed, check for
any stored DTCs, rectify as necessary and repeat the rear preload motor test. If the rear preload
motor still doesn’t function correctly, contact Triumph service.
Turn the ignition off and disconnect the Triumph diagnostic tool. Allow 15 seconds for the chassis ECM to
power down. 7.
Note
With the ignition switch turned off, the Triumph diagnostic tool will prevent the chassis ECM from
powering down if it is left connected to the motorcycle.
To enable the chassis ECM to power down, disconnect the diagnostic tool from the motorcycle.
After running the rear preload motor up/down tests, the rear preload motor will automatically
recalibrate the next time the ignition switch is turned on, provided the chassis ECM is first allowed
to power down.
Turn the ignition switch on and allow the rear preload motor to calibrate, see Rear Suspension Unit Preload
Motor Calibration. During calibration, observe the rear preload motor adjustment collar moving through its
full adjustment range to verify correct motor operation. 8.
Swinging Arm - Disassembly
WARNING
If the engine has recently been running, the exhaust components may be hot to the touch. Contact with the
hot components may cause damage to exposed skin. To avoid skin damage, always allow the hot parts to
cool before working on the exhaust system.
WARNING
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider’s seat (see Rider’s Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the exhaust silencer (see Exhaust System - Removal).
Remove the rear wheel (see Rear Wheel - Removal).
Remove the rear bevel box (see Rear Bevel Box - Removal).
Disconnect the swinging arm position sensor linkage from the swinging arm.
1.
Disconnect the electrical connector for the rear suspension unit damping solenoid. 2.
Tiger Explorer XR Series
422 of 746
REAR SUSPENSION