Triumph Tiger Explorer XR 2016, Service Manual

Page: 717 / 750

cjlh
Fixings 1.
Electrical connector 2.
Instruments 3.
Refit the windscreen motor (see Windscreen Motor - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to
4.5 Nm .
Refit the rider’s seat (see Rider’s Seat - Installation).
Headlight Bulb Replacement
Position Light Bulb Replacement
WARNING
Adjust road speed to suit the visibility and weather conditions in which the motorcycle is being operated.
Make sure that the head light beam is adjusted to illuminate the road surface sufficiently far ahead without
dazzling oncoming traffic. An incorrectly adjusted headlight may impair visibility causing an accident.
WARNING
Never attempt to adjust a headlight beam when the motorcycle is in motion.
Any attempt to adjust a headlight beam when the motorcycle is in motion may result in loss of control and an
accident.
CAUTION
Do not cover the headlight or lens with any item likely to obstruct air flow to, or prevent heat escaping from,
the headlight lens.
Covering the headlight lens during operation with items of clothing, luggage, adhesive tape, devices intended
to alter or adjust the headlight beam or non genuine headlight lens covers will cause the headlight lens to
overheat and distort, causing irreparable damage to the headlight assembly.
Damage caused by overheating is not considered a manufacturing defect and will not be covered under
warranty.
If the headlight must be covered during use - such as taping of the headlight lens required during
closed
‑
course conditions - the headlight must be disconnected.
Note
The headlight can be adjusted by means of vertical and horizontal adjustment screws located on the
rear of the headlight.
3
1
Tiger Explorer XR Series
713 of 746
ELECTRICAL