Triumph Tiger Explorer XR 2016, Service Manual

Page: 404 / 750

brake fluid reservoir, lay the assembly aside.
Note the routing of the heated grips harness, then carefully remove the harness from the handle bars and
lay aside.
15.
WARNING
Always return the risers to their original position. Operating the motorcycle with a handlebar position that is
unfamiliar may lead to loss of control or an accident.
Note
The bolt positions shown are in the standard position, as delivered from the factory. If the
handlebars have been adjusted, the bolt positions will be reversed.
Note the orientation of the risers for installation, in order that they can be returned to the same
position when the repair operation is complete.
Note the position of the 8 mm and 10 mm bolts for installation.
Remove the handlebar rear (8 mm threaded) clamp bolts, and then the front (10 mm threaded) clamp and
riser bolts. Remove the handlebars while removing the front of the right hand switch cube from the
handlebar. 16.
2
1
chiv_2
10 mm bolts 1.
8 mm bolts 2.
Ensure that the risers are in the same orientation as noted for removal. 1.
Fit the front of the right hand switch housing to the right hand side of the handlebar. 2.
Locate the handlebar assembly into the risers. Fit the upper clamps and the 10 mm bolts. 3.
Rotate the handlebar so that the alignment mark on the handlebar aligns with the front left hand split line of
the clamp riser. 4.
2
3
1
Tiger Explorer XR Series
400 of 746
REAR SUSPENSION