Triumph Tiger Explorer XR 2016, Service Manual

Page: 122 / 750

chhv
4
Bleed nipple dust cap 1.
Bleed nipple 2.
Bleed tube 3.
Container 4.
Note
During bleeding, do not allow the fluid level to fall below the lower level mark in the reservoir. If the
level is allowed to fall below this mark, air may enter the system and the sequence of bleeding must
be repeated.
Maintain the clutch fluid level between the upper and lower levels whilst bleeding is being carried out. 12.
When all the air has been expelled from the system, hold in the clutch lever and close the bleed nipple.
Tighten to
5 Nm .
13.
Fill the reservoir to the upper level. 14.
WARNING
Use only DOT 4 specification brake and clutch fluid as listed in the General Information section of this
manual. The use of clutch fluids other than those DOT 4 fluids listed in the General Information section may
reduce the efficiency of the clutch system leading to an accident.
Replace the reservoir cover and diaphragm ensuring correct fitment of the diaphragm. Tighten the screws to
1.5 Nm .
15.
Remove the transparent bleed pipe. 16.
Replace the bleed nipple dust cap. 17.
Refit the slave cylinder cover. Tighten the new fixings to 4 Nm . 18.
1
2
chhu
Slave cylinder cover 1.
Fixings 2.
Reset the adjuster wheel on the clutch lever to the original setting. 19.
WARNING
Tiger Explorer XR Series
118 of 746
CLUTCH