Triumph Tiger Explorer XR 2016, Service Manual

Page: 320 / 750

WARNING
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Position the airbox to its forward mounting and push home. 1.
Refit the air intake duct to the frame. 2.
Press down on the rear of the airbox to locate the intake rubbers to the throttle bodies. 3.
CAUTION
Always ensure that all 3 intake rubbers seal to the throttles through 360° as poor performance and lack of
power can result from incorrect sealing.
Fit and tighten the airbox rear fixings to 5 Nm . 4.
Fit the breather drain hose to the rear of the airbox. 5.
Reconnect the hose to the secondary air injection control valve. 6.
Connect the multiplugs to the following: 7.
Air temperature sensor
Secondary air injection control valve.
Refit the MAP sensor (see Manifold Absolute Pressure (MAP) Sensor - Installation).
Refit the fuel tank (see Fuel Tank - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to
4.5 Nm .
Refit the rider’s seat (see Rider’s Seat - Installation).
Air Filter Element - Removal
WARNING
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider’s seat (see Rider’s Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the fuel tank (see Fuel Tank - Removal).
Disconnect the multiplug from the air temperature sensor.
1.
2
1
chkb_1
Tiger Explorer XR Series
316 of 746
FUEL SYSTEM / ENGINE MANAGEMENT