instructions for
motorcycle wheel chock
model no’s:
wc06, wc07, wc08
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFety
wArNING!
the warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that may
occur. it must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator. it is the operators responsibility to secure the load. check with vehicle manufacturer’s manual before installing.
9
make sure the wheel of the equipment being mounted or dismounted is aligned with the chock.
9
inspect chock before each use. check fasteners for tightness, replace any worn or damaged parts.
8
Do Not
attempt to use a chock that is damaged in any way.
8
Do Not
modify the chock in any way.
9
Proper care and maintenance of the chock is critical to safety.
9
Proper use of this product is critical to safety. improper use may result in personal or property damage which is not covered by the
warranty.
2.
i
INtroDuctIoN
Wheel chock supports the wheel of the motorcycle when in transit or storage. made from black powder coated heavy-duty tubular steel with pre-
drilled holes and fixings which allow chock to be fixed to any suitable surface. A range of three sizes is available covering maximum tyre widths of
95mm, 140mm, and 165mm.
3.
SpecIFIcAtIoN
model number
maximum tyre Width
Wc06
95mm
Wc07
140mm
Wc08
165mm
4. coNteNtS
Part
description
Quantity
Part
description
Quantity
A
Wheel chock
1
e
1/4” x 5/8” screws
2
B
spacer mounting Plates
2
f
2” screws
4
c
slotted mounting Plates
2
G
Washers
4
d
steel threaded studs
2
H
locking nuts
4
Wc06, Wc07, Wc08 | issue 1 30/11/17
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear protective
gloves