Teledyne T101, Operation Manual, Page: 135 / 375

Teledyne ML – T101 Operation Manual Operating Instructions
131
4.8.2.2. Editing DAS Data Channels
DAS configuration is most conveniently done through the APICOM remote control
program. The following list of key strokes shows how to edit using the front panel.
Main Data Acquisition Menu
Edit Data Channel Menu
SAMPLE RANGE = 500.0 PPB H2S =XXX.X
< TST TST > CAL
SETUP
SETUP X.X 0) CONC: ATIMER, 2, 4032, R
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X PRIMARY SETUP MENU
CFG
DAS RNGE PASS CLK MORE EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
EXIT will return to the
previous SAMPLE
display.
SETUP X.X DATA ACQUISITION
VIEW
EDIT EXIT
Moves the
display up &
down the list of
Data Channels
Inserts a new Data
Channel into the list
BEFORE the Channel
currently being displayed
Deletes The Data
Channel currently
being displayed
Exports the
configuration of all
data channels to
RS-232 interface.
Exits to the Main
Data Acquisition
Menu
SETUP X.X NAME:CONC
<SET SET> EDIT PRNT EXIT
Moves the display
between the
properties for this data
channel.
Reports the configuration of current
data channels to the RS-232 ports.
EXIT returns to the
previous Menu
To edit the channel name, see next sequence.
When editing the data channels, the top line of the display indicates some of the
configuration parameters. For example, the display line:
0) CONC: ATIMER, 4, 800
translates to the following configuration:
Channel No.: 0
NAME: CONC
TRIGGER EVENT: ATIMER