Tecnoalarm TP16-256, Installer Manual

Page: 154 / 248

Programming by Console Installer Manual - TP16-256
5-14
Menu 5
Functions
XXXXXXX 1
Zone xxx [ ]
MENU
5 5
5 5 5
5.7 PROGRAMMING OF THE FUNCTIONS
+
yw
to select the menu (5)
+
#
YES to confirm the selection
Submenus
z
Siren
Defines whether the siren is to be activated if the zone in question has released
an alarm.
z
Pgm
Defines whether the programmable logic output is to be activated if the zone in
question has released an alarm.
z
By-pass
Defines if the zone you are going to select can be partset (see configuration of
codes and keys).
If the program is armed and the zone can be partset, upon entering of an
appropriate code or insertion of a by-pass key the zone is temporarily disabled
for the detection of alarms. It will be re-enabled the next time a code enabled for
by-pass is entered or a by-pass key is inserted.
z
Coinciding
Defines whether the zone you are going to select is part of the group of
coinciding zones.
Upon detection of an alarm on one of the coinciding zones, the control panel
starts a 15-minutes timer and verifies two conditions:
„
The detector which has released the alarm is inhibited for 6 seconds. If
after 6 seconds but within 15 minutes another alarm is detected by the
same zone, the alarm is released (double knock).
„
If within 15 minutes an alarm is detected on another coinciding zone, the
alarm is released.
z
Chime
Defines whether the zone you are going to select is enabled for chime.
If a chime zone is opened (and the relative program is disarmed), the chime is
activated. The buzzer situated on the console can be programmed so as to be
activated for 2 seconds upon every opening of the zone, or for 3 seconds upon
every opening of the zone and continuously if the zone remains open.
z
Non excludib.
Defines the zone you are going to select as not excludible manually.
z
Common
Defines whether the zone included in more than one program is part of the group
of common zones.
The common zones are enabled for the detection of alarms only if all the
programs they are included in are armed simultaneously.
Commands available
+
yw
to select the function
+
#
YES to confirm the selection
5.7.1 ZONE ASSOCIATION
After selecting the function:
+
yw
to select the zones (from 1 to 256)
+
#
YES to confirm the selection
Viewing of the current settings
[ ] Zone not associated
The zone viewed has not been associated to the function selected.
[ # ] Zone associated
The zone viewed has already been associated to the program selected.
Commands available
+
#
YES to associate the zone viewed to the function
+
*
NO to cancel a possible existing association
+
EXIT to accept programming and quit the submenu
Functions 1
Siren
Functions 2
Pgm
Functions 3
By-pass
Functions 4
Coinciding
Functions 5
Chime
Functions 6
Non excludib.
Functions 7
Common