Tecnoalarm TP16-256, Installer Manual

Page: 160 / 248

Programming by Console Installer Manual - TP16-256
5-20
Timers 1
Timer 01
5.10.1.1 PROGRAMMING OF THE PERIOD
The frequency of repetition of the test call is programmed in two steps, first the value
(000 to 255), then the time unit.
Commands available
+
0
...
9
to enter the value
+
#
YES to confirm the setting
5.10.1.2 PROGRAMMING OF THE ATTRIBUTE OF THE PERIOD
After entering the value, associate the time unit requested (not active, minutes, hours,
days). If you select not active, the test call is disabled.
Commands available
+ yw
to select the item
+
#
YES to confirm the selection
+
EXIT to accept programming and quit the submenu
5.10.1.3 BINDING OF TEST CALL TO SYSTEM STATUS
Permits binding of the execution of the test call to system status, i.e. only if the control
panel is armed.
Viewing of the current settings
[ ] Test call not bound to system status (i.e. always active)
[ # ] Test call bound to system status (i.e. active if the control panel is armed)
Commands available
+
#
YES to bind the test call to system status
+
*
NO to free the test call from system status
+
EXIT to accept programming and quit the submenu
5.10.1.4 PROGRAMMING OF THE STARTING HOUR
Permits programming of the starting hour of the test call cycle.
Commands available
+
yw
to select the item
+ 0
...
9
to enter the value
5.10.2 CONFIGURATION OF THE TIMERS
The timers permit the automatic execution of determined functions (actions), such as
arming/disarming and by-pass, with scheduled intervals.
The control panel provides 32 independent timers.
SELECTION OF THE TIMERS
+
yw
to select the timer (from 1 to 32)
+
#
YES to confirm the selection
Submenus
z
Action Defines the function the timer is to execute
z
Attribute Defines the activation period of the timer
z
Programs Defines the programs/remote controls the timer is to act on
z
Time Defines the hour of activation of the timer
z
Blocked Permits skipping of the following activation of the timer
Commands available
+
yw
to select the parameter
+
#
YES to confirm the selection
5.10.2.1 PROGRAMMING OF THE ACTION
Every timer can be programmed so as to execute the following functions:
z
Arming Arming of the program/s associated
z
Disarming Disarming of the program/s associated
z
Beg. by-pass Activation of by-pass on the program/s associated
z
By-pass end Deactivation of by-pass on the program/s associated
z
Remote activation Activation of the remote control/s associated
z
Remote deactivat. Deactivation of the remote control/s associated
z
Ctrl Arming Arming with alarm check
Commands available
+
yw
to select the item
+
#
YES to confirm the selection
+
EXIT to accept programming and quit the submenu
Timer 01 2
Attribute
Timer 01 3
Programs
Timer 01 4
Time
Timer 01 5
Blocked [ # ]
Timer 01 1
Action