Tecnoalarm TP16-256, Installer Manual

Page: 165 / 248

TP16-256 - Installer Manual Programming by Console
5-25
MENU
10 10 10 10 10
Menu 10
Telephone
Telephone 1
Setting
Setting 1
Answer [ ]
Setting 2
Pulse [ ]
Setting 3
Line test [ ]
Setting 4
Dial hum [ ]
Setting 5
Global block [ ]
Learn.
Waiting
Learn.
Completed
WL key 01
Learn.
[ ]
5.14.1 LEARNING OF THE WIRELESS KEY
Every wireless key before use must be associated to the control panel. This process
consisting in the storage of the device ID code is commonly called learning.
Viewing of the current settings
[ ] Wireless key has not yet been learnt
[ # ] Wireless key has been learnt
DELETION OF AN EXISTING WIRELESS KEY
To delete an existing association, press the star key (*).
LEARNING
While on the display is viewed Learn. Waiting (the system is ready for learning),
press the button 1 for at least 10 seconds to initiate the process.
During this period of time, the device transmits its ID code to the control panel.
After learning, on the display is viewed
Learn. Completed .
5.15 PROGRAMMING OF THE TELEPHONE PARAMETERS
+
yw
to select the menu (10)
+
#
YES to confirm the selection
Submenus
z
Setting Telephone parameters
z
PABX Number of the outgoing line for PABX switchboards
z
Channel A Configuration of channel A
z
Channel B Configuration of channel B
(...)
z
Channel H Configuration of channel H
z
Call back Call back number
z
Mobile Configuration of the GSM module
Commands available
+
yw
to select the function
+
#
YES to confirm the selection
5.15.1 SETTINGS
Submenus
z
Answer
Enables the control panel for answering to incoming calls
[ # ]
Answering mode enabled
z
Pulse
Permits the selection of the dialing mode
„
Pulse (decadic) - recognized by any telephone switchboard
„
DTMF (tone) - for telephone switchboards that recognize tones (quick dialing)
[ ] DTMF dialing
[ # ] Pulse dialing
z
Line test
Permits enabling/disabling of the telephone line test (voltage of the telephone line
is/is not checked prior to dialing)
[ ]
Line test enabled
[ # ] Line test dis abled
z
Dial hum
Permits enabling/disabling of the dial hum check (i.e. the dial tone is/is not
checked prior to dialing).
[ ]
Dial hum check disabled
[ # ] Dial hum enabled
z
Global block
Interruption of all the active digital and vocal calls. On reception of the blocking
command, the control panel can:
„
Block the single channel
On reception of the blocking command, the control panel checks if there are
events queued up. If there are not or a single type protocol has been
programmed, it closes the communication and blocks the active phone call
cycle of this channel. In all the other cases, the next event is transmitted.