Tecnoalarm TP16-256, Installer Manual

Page: 157 / 248

TP16-256 - Installer Manual Programming by Console
5-17
z
Sound report (enabling of the sound report)
For each of the above warnings the corresponding voice message is sent out.
Viewing of the current settings
[ ] Buzzer not associated to the parameter selected
[ # ] Buzzer associated to the parameter selected
Commands available
+
yw
to select the parameter
+
#
YES to enable the buzzer for the parameter selected
+
*
NO to cancel a possible existing association
+
EXIT to accept programming and quit the submenu
5.9.4 CONFIGURATION OF THE PROGRAMMABLE OUTPUTS
Permits the definition of the meaning and the stand-by status of the programmable
logic outputs of the system, i.e. CPU board and input expansions (1 to 32) connected.
Commands available
+
yw
to select the module
+
#
YES to confirm the selection
Submenu (options available for every module)
z
Sir.Int Programming of the meaning of the logic output SR INT
z
Sir.Ext Programming of the meaning of the logic output SRA
z
Out1 Programming of the meaning of the logic output OUT1
z
Out2 Programming of the meaning of the logic output OUT2
z
Sir.Int inv. Programming of the logic output SR INT with reverse stand-by
status
z
Sir.Ext inv. Programming of the logic output SRA with reverse stand-by
status
z
Out1 inv. Programming of the logic output OUT1 with reverse stand-by
status
z
Out2 inv. Programming of the logic output OUT2 with reverse stand-by
status
Commands available
+
yw
to select the option
+ #
YES to confirm the selection
5.9.4.1 PROGRAMMING OF THE STAND-BY STATUS
According to programming, the logic outputs have the following stand-by status:
Normal condition Reverse condition
THE LOGIC OUTPUTS SRA AND SR INT OF THE CPU AND THE INPUT
EXPANSIONS
SRA
Stand-by: +13.8V Stand-by: high impedance
Alarm: high impedance Alarm: +13.8V
SR INT Stand-by: high impedance Stand-by: GND (earth)
Alarm: GND (earth) Alarm: high impedance
THE LOGIC OUTPUTS OUT1+ AND OUT2- OF THE CPU
OUT1+
Stand-by: high impedance Stand-by: +13.8V
Alarm: +13.8V Alarm: high impedance
OUT2- Stand-by: high impedance Stand-by: 0V
Alarm: 0V Alarm: high impedance
THE LOGIC OUTPUTS OUT1 AND OUT2 OF THE INPUT EXPANSIONS
OUT1
Stand-by: high impedance Stand-by: +13.8V
Alarm: +13.8V Alarm: high impedance
OUT2 Stand-by: high impedance Stand-by: 0V
Alarm: 0V Alarm: high impedance
Viewing of the current settings
[ ] Normal stand-by status
[ # ] Reverse stand-by status
Commands available
+ yw
to select the stand-by status
+
#
YES to activate the reverse stand-by status
+
*
NO to deactivate the reverse stand-by status
+
EXIT to accept programming and quit the submenu
5.9.4.2 PROGRAMMING OF THE MEANING OF THE LOGIC OUTPUTS
According to programming, the logic outputs assume the following meanings:
Buzzer 5
Warn. by-pass [
]
Buzzer 6
Warn. autom. [ ]
Buzzer 7
Sound report [ ]
Programmable 1
Cntrl panel
Cntrl panel 1
Sir.Int
Cntrl panel Sir.Int 1
Stand-by