Tecnoalarm TP16-256, Installer Manual

Page: 175 / 248

TP16-256 - Installer Manual Programming by Console
5-35
Codes 4
User codes
User codes 1
Code 001
Code 001 1
Code
Code 001 2
Periods
Code 001 3
Programs
Code 001 4
Attributes
then be enabled to view the general alarm log and the log relating to the
programs the code is enabled for as well as program determined parameters.
z
Excl. disab. (disabling of zone exclusion)
Disables both the voluntary exclusion of zones and the automatic exclusion of
open zones. If the control panel is armed in the presence of open zones, these
will release an alarm at the end of the arming phase.
z
Excl. Remote controls (disabling of remote controls exclusion)
Disables the user for remote arming or disarming of the programs associated by
telephone.
Viewing of the current settings
[ ] Option not enabled
[ # ] Option enabled
Commands available
+
yw
to select the item
+
#
YES to enable the item selected
+
EXIT to accept programming and quit the submenu
5.18.4 PROGRAMMING OF THE STANDARD USER CODES
The user codes are the codes enabled to arming/disarming or by-pass the control
panel.
The user codes available are up to 200.
SELECTION OF THE CODE
+ yw
to select the code (1 to 200)
+
#
YES to confirm the selection
Submenus
z
Periods
Permits the association of the access periods (from 1 to 8) during which the code
is to be enabled
z
Programs
Permits the association of the programs (from 1 to 32) the code is to arm/disarm
or partset
z
Attributes
See § 5.18.3.
Viewing of the current settings
[ ] Option not enabled
[ # ] Option enabled
Commands available
+
yw
to select the item
+
#
YES to enable the item selected
+
EXIT to accept programming and quit the submenu
WARNING
The values of the standard user codes can only be changed, if you enter programming with the
master code and the user code modification (see § 5.17) is
disabled . If the user code modification is
enabled, the holders of the standard user codes will be entitled to change their own codes and the
master code will no longer have access to programming of the code values.