Tecnoalarm TP16-256, Installer Manual

Page: 78 / 248

Hardware - Wireless Expansion Modules Installer Manual - TP16-256
2G-8
2G.5 SAEL 2000 WL WIRELESS SIREN
The SAEL 2000 WL is a wireless siren (bidirectional radio transmission) equipped with an acustic advisor and low
consumption XENON flash. It can be programmed to function either as indoor or outdoor siren.
Power supply is guaranteed by a 7.2V-13Ah lithium battery.
Data exchange with the control panel is bidirectional using 2 operationg frequencies (RX 868MHz and 433MHz).
2G.5.1 BATTERY
BATTERY VOLTAGE CHECK
Battery voltage control is done prior to every transmission. If the battery charge drops below the limit of low battery,
the siren emits a sequence of sounds and transmits low battery signaling to the control panel on every
arming/disarming. In case of low battery, it is recomended to replace immediately the battery. The sirens, howerver,
continues to work but with a reduction of sound of level proportionate to the reduction of battery voltage.
BATTERY REPLACEMENT
z
Put the control panel into maintenance.
The siren passes automatically into maintenance mode and emits a low volume beep.
z
Open the cover of the siren
the antiopening tamper is disabled in maintenance
z
Remove the battery and press the button TEST
z
Connect the new battery
The siren passes automatically into maintenance mode
z
Press the button TEST to check battery voltage of the new battery
Verify that the yellow LED is lit, then:
• Battery charged No sound signaling
• Battery discharged Bitonal sound signaling
z
Verify the communication with the siren by the initiating radio test Siren Connection on the control panel
z
Verify siren sounding by arming the control panel and violating a zone
z
Close the cover
z
Quit the maintenance mode on the control panel and check end of the low battery signaling