Tecnoalarm TP16-256, Installer Manual

Page: 164 / 248

Programming by Console Installer Manual - TP16-256
5-24
MENU
13 13
13 13 13
5.14 CONFIGURATION OF THE WIRELESS KEYS
+
yw
to select the menu (13)
+
#
YES to confirm the selection
The control panel provides up to 60 wireless keys with three function keys each. The
wireless keys can be programmed individually so as to execute different functions.
SELECTION OF THE WIRELESS KEY
+
yw
to select the wireless key (from 1 to 60)
+
#
YES to confirm the selection
Submenus
z
Periods
Defines the access period (from 1 to 8) during which the wireless key is enabled
z
Ass. buttons
Permits the association of the following functions to the 3 function keys:
„
Disarming (of all the programs that have previously been armed by the
wireless key)
„
Arm. program (a determined program from 1 to 16)
„
Dis. program (a determined program from 1 to 16)
„
ON/OFF rem ctrl (a determined remote control from 1 to 16)
„
ON rem ctrl (a determined remote control from 1 to 16)
„
OFF rem ctrl (a determined remote control from 1 to 16)
z
Attributes
„
By-pass
Defines whether the wireless keys is to be used for arming and disarming or
activation and deactivation of by-pass. If the attribute is selected, the function
of the arming and disarming keys change as follows:
- Arm. program becomes activation of by-pass of the program
- Dis. program becomes deactivation of by-pass of the program
- Disarming becomes general deactivation of by-pass
„
Conf. dis (confirmation of disarming)
If the attribute is selected, disarming by wireless key releases a hold-up alarm
unless it is confirmed by entering a valid code within the delay programmed
(see programming of time parameters). If the code is entered either not at all
or late, a silent hold-up alarm is released and the outputs programmed are
activated.
„
Autom. abort (automatic communicator block on disarming)
If the attribute is selected, upon disarming by wireless key all the active
telephone channels as well as those waiting to be activated are blocked.
„
Byp gen. al. (by-pass general alarms)
Permits the by-pass of the general alarms, i.e. arming in the presence of the
following alarms:
-
Tamper
- Low battery
- Power failure
- Supervision
- Trouble
„
Duress
Enables the release of a panic alarm by pressing the keys 2 and 3 of the
wireless key simultaneously.
„
Excl. disab.
Disables both the voluntary exclusion of zones and the automatic exclusion of
open zones. If the control panel is armed in the presence of open zones, these
will release an alarm at the end of the arming phase.
z
Learning (see § 5.14.1)
Viewing of the current settings
[ ] Attribute has not been associated to the wireless key selected
[ # ] Attribute has been associated to the wireless key selected
Commands available
+
#
YES to associate the function to the wireless key
+ *
NO to cancel an existing association
+
EXIT to confirm and quit
Menu 13
WL keys
WL keys 1
Periods
WL keys 2
Ass. buttons
WL keys 3
Attributes
WL keys 4
Learning