Tecnoalarm TP16-256, Installer Manual

Page: 106 / 248

Programming by PC Installer Manual - TP16-256
4-14
PROPERTIES KEY ZONE
The key zone can be set so as to work in the following way:
z
Pulse
Pulse functioning is indicated if a push-button is connected
to the key zone.
z
ON/OFF
On/off or switch functioning is indicated if an ON/OFF key
is connected to the key zone.
SINGLE ARMING BY KEY
The keys can be enabled for merely single arming. In this way,
upon every introduction of the key into the key reader another
program it is enabled for will be selected whereas the previous
one is deselected.
COUNTRY
Permits to set the special versions depending on the country of
destination.
MODIFICATION OF CODE BY USER
By default the master code is the only one enabled for the
modification of the user codes. If the item is checked the
standard users are enabled for the modification of their proper
code, but cannot view nor modify the other codes.
INVERSION OF REPORT CODES
Permits the inversion of the report codes to be sent during the
digital transmissions.
To be used only if specifically requested.
LEVEL OF WIRELESS TRANSMISSION
Every level of wireless transmission a different output power of
the wireless receiver-transmitter corresponds to.
AUTOMATIC TAMPER DISABLING
Permits the self-exclusion of the tamper alarms, if a determined
number of tamper alarms is counted in a determined period of
time.
z
Disabled
z
Automatic tamper disabled after 1...255 alarms (cycles)
TAMPER RE-ENABLING
Permits programming of the period of time (in hours and
minutes) after which the tamper control is re-enabled.
ZONE ANTIMASKING CONTROL
Permits setting of the antimasking control of the zones:
z
Always active
z
Alarm if program armed
z
Alarm and signaling if program armed
To enable an option, click on the box beside it.
Once you have set the system options, press:
z
OK to confirm and close the zone configuration
tables
z
Abandon to undo the system option settings
WARNING
Prior to setting the level of wireless transmission check for possible output power limitation in your
country.
WARNING
Valid for the key readers connected via key interface TP SKN only, but not for the key reader with
mini keypad TP SK6N.