Tecnoalarm TP16-256, Installer Manual

Page: 41 / 248

TP16-256 - Installer Manual Input Expansion Modules - Hardware
2A-11
2A.5.3 TERMINALS
WARNING
z
Values about programmable logic output OUT1 and OUT2 indicated with * concern standard
functionnement status. It is possible to invert the status.
z
Never conect two devices with the same address.
z
Terminals SENSOR BUS are interchangeable. It is possible to connect up to 2 devices on
each BUS.
z
The terminal SY must to be connected only on MINIEXPLORER DOPPLER BUS barriers.
z
To connect a detector type MINIEXPLORER DOPPLER BUS having two separates parties,
always use the two nearest inputs began to the impaire position (ex: inputs Z1 and Z2, or Z5,
Z6 but never Z2 and Z3).
Te rm ina l De scription Type
AC
AC
AC power supply Input
14V + Battery recharge voltage Output
14V - GND (earth) -
SRA+ Self-powered indoor siren Output Standby: 13.8V DC Alarm: high impedance
SR+ Indoor siren Output Standby: high impedance Alarm: 13.8V DC
SR- GND (earth) -
OUT1- Programmable logic output Output Standby: high impedance (*) Alarm: negative voltage
OUT2- Programmable logic output Output Standby: high impedance (*) Alarm: negative voltage
+ Power supply Output
+
Output
-
Output
A
B
SY
Synchronization Output
+ Output
- Output
A
B
+ Output
- Output
A
B
RS485 serial bus
Input
Output
RS485 serial bus
Input/output sta tus
30V (AC)
GND (earth)
14.4V DC - For self-powered outdoor siren only
OUTPUTS
13.8V DC
SIREN BUS
Synchronization for barriers
RS485 serial bus power supply
13.8V DC
GND (earth)
RS485 serial bus power supply
14.4V DC
GND (earth)
RS485 serial bus
Input
Output
RS485 serial bus
RS485 serial bus
Input
Output
RS485 serial bus
GND (earth)
SENSOR BUS
RS485 serial bus power supply
13.8V DC
GND (earth)