Tecnoalarm TP16-256, Installer Manual

Page: 246 / 248

Appendix C - Code Management Installer Manual - TP16-256
C-4
Commands available
+
yw
to select the menu
+ #
YES to confirm the selection
Enter the programming menu.
Enter the code menu.
On the display is viewed
Codes .
In the code menu the following parameters can be programmed:
z
Master code
z
Standard user code
Commands available
+
wy
to select the code to be programmed
+ #
YES to confirm the selection
OPTION "MODIFICATION OF CODE BY USER" ENABLED
If the option is enabled, it will not be possible to view or change the code. It is masked
by a series of stars.
Commands available
+
*
NO to delete the current code (i.e. zeroize its value)
+
#
YES to reset the default value (i.e. 123456 for the master code and a
6-digits code with the code number starting from the right for the
standard user codes, e.g. 000001, 000002, 000056)
OPTION "MODIFICATION OF CODE BY USER" DISABLED
If the option is disabled, the current code will be viewed.
Enter the new code.
Press the EXIT key to confirm and quit.
C.3 INSTALLER CODE
The installer code is not subject to the same rules as the user codes. It is infact
possible to program a user code with the same value as the installer code.
The only exception is the default installer code, as it is reserved.
The conflict of the two codes is solved upon entering of the code. Differently than the
control panels of the previous generations, access is not given to the installer menu in
any case seeing that the code entered corresponds to the installer code, but rather to
the user menu.
CONFLICT INSTALLER-STANDARD USER CODE
If the installer code is the same as one of the user codes, e.g.:
z
Installer code 99999
z
Standard user code 200 99999
upon entering of the code, access is given to the standard user menu with the
attributes enabled for the code number 200.
On the display is viewed the opposite message.
To force access to the installer menu (maintenance), enter the default master code
first (e.g. 54321):
+ 54321
On the display is viewed Password Installer .
Then enter the current installer code (e.g. 99999):
+
99999
Access is now given to the installer menu.
This procedure offers the following advantages:
1)
The installer does not run the risk that his code is discovered.
2) The installer can continue to enter the installer menu using the new procedure
only in case his code has been cloned.
Menu 11
Codes
Codes 3
Master code
Master code
*****
Master code
12345
Codes 4
User codes
Master code 1
Code
- ACCESS -
User 200
Password
Installer
User codes 1
Code 01
WARNING
In case of code reset or deletion of system configuration (see special procedures), all the standard
user codes are disabled (000000 = unvalid code) and the installer and master code will be set with
default values (654321 for the installer code, 123456 for the master code).