Tecnoalarm TP16-256, Installer Manual

Page: 54 / 248

Hardware - Keypoints Installer Manual - TP16-256
2C-4
2C.3.2 TAMPER PROTECTION OF THE KEY READERS
It is recommended to mount the key readers inside special tamper protected casings.
2C.4 NOTES FOR ALL KEYPOINTS
END OF SERIAL BUS
The end-of-serial-bus jumper is to be inserted on the last device connected in series only.
MOUNTING OF TAMPER SWITCHES
The electronic keypad TP SDN and the key interface TP SKN as well as the readers connected have to be mounted
inside tamper protected casings. The tamper switches provided by the casings must always be wired to the
electronic board of the modules.
2C.5 DIP-SWITCH SETTINGS
The SW1 dip-switch permits programming of the address of the modules on serial bus. There must not be two
devices with the same address.