Tecnoalarm TP16-256, Installer Manual

Page: 62 / 248

Hardware - Output Expansion Modules Installer Manual - TP16-256
2D-8
2D.5 ADDRESS CLONING
Iserting the W1 jumper, it is possible to clone the address of a module (clone a module). Using this function, the
module accepts the commands for the outputs corresponding to its address, but does not respond to the control
panel.
It is possible to duplicate an address in order to control the same outputs from differents points of the installation.
WARNING
Using the clone mode, it is not possible to recognize the tamper alarms (tamper module and loss of
connexion with the control panel). It is possible to add a cloned module only if a standard (uncloned)
module with the same address has been installed because the control panel never sees a cloned
module on serial bus.