Simrad GO XSE Series, Operator'S Manual

Page: 98 / 242

Outboard autopilot
Safe operation with the autopilot
Warning:
An autopilot is a useful navigational aid,
but DOES NOT replace a human navigator.
Warning:
Ensure the autopilot has been installed
correctly, commissioned and calibrated before use.
Ú
Note:
For safety reasons a physical standby key should be
available.
Do not use automatic steering when:
• In heavy traffic areas or in narrow waters
• In poor visibility or extreme sea conditions
• When in areas where use of an autopilot is prohibited by law
When using an autopilot:
• Do not leave the helm unattended
• Do not place any magnetic material or equipment near the
heading sensor used by the autopilot system
• Verify at regular intervals the course and position of the vessel
• Always switch the autopilot to standby and reduce speed in due
time to avoid hazardous situations
Autopilot alarms
For safety reasons it is recommended to turn on all autopilot alarms
when operating the autopilot.
For more information, refer to
"Alarms" on page 198.
Selecting active autopilot
If both an autopilot computer and a trolling motor are configured
for MFD control, only one of them can be active at a time.
Buttons for both autopilots are shown in the control bar.
Activate an autopilot by selecting the relevant button in the control
bar, then select the switch button in the autopilot controller.
10
98
Outboard autopilot | GO XSE/XSR Operator Manual