User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
The arrows placed in the upper right corner of the screen allow you to
move to the next view. The middle button allows you to directly select a
particular view.
Parameters of
View
menu are:
–
Display mode
- this parameter allows the user to select the presentation of the data
in the displayed group (see parameter:
Displayed group
). For possible modes see
Chapter 6.3.3. Data panels
Chapter 7.14. GROUPS
–
Displayed group
- allows the user to select a group displayed at startup. If the
Display mode
is chosen as
many groups
, the parameter
Display
group
selects the
first of five following groups displayed on the screen (the mode of many groups
presents 5 groups in one window). For example, when setting the parameter to
Display group=Group 8
then the display will show: starting from the left side of:
Group 8 -> Group 9 -> Group 10 -> Group 1 -> Group 2,
–
Display time
- this parameter is visible for the
Triggering mode
:
by time
, it sets the
duration (in seconds) of the selected view,
–
Add a new view
button - adds a new view to the list
–
Delete this view
button - deletes a selected view from the list,
–
Move to position
- this parameter allows the user to move the current view to the
appropriate position,
Example:
The steps to create four views are as follows:
1.
In the Change mode parameter select the detailed list,
2.
Press the
Setup list
button and enter the
View
menu,
3.
Set parameters for the first View,
The arrows placed in the upper right corner of the screen allow you to
move to the next view. The middle button allows a direct selection of a
particular view.
4.
To add or delete further views use the
Add a new view
button or
Delete this view
button, respectively,
5.
When the user wants to add a view between the existing views, e.g. between views 2
and 3, the user can choose the two following ways:
•
select the 2nd view (by the arrows in the upper right corner of the screen) and
then add a new view by clicking the
Add a new view
button,
•
after adding a new view at the end of the list, the
Move to position
parameter
set as
3
value,
6.
When finished, the user can see all the defined views by clicking the middle button
between the arrows in the upper right corner of the screen,
74