Simex MultiCon CMC-99/141, User Manual

Page: 207 / 332

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
The Controller 1 has been assigned to various logical channels creating independent control
loops. It should be noted, that a situation in which both: the controller in autotuning
parameters and logical channel can be assigned the same logical channels for
Set point
value and Feedback (in the Fig. 7.122 , logical channels SP1 and FB1). At start-up autotuning
of Controller 1 all logic channels in Controller mode with assigned controller 1 (logic channel
1, 2, n) will use the same autotuning parameters (SP1 and FB1) so they will generate the
same value at the output. After the autotuning end logic channels in controller mode with
assigned Controller 1 will go to normal operation of the regulator creating independent
control loops.
There are 2 methods of configuring the controllers:
- through the menu Controllers in the Device Configuration menu (see Fig. 7.123 ),
- directly in the Logical channel in the Regulator mode by pressing the button Source
configuration (see
Fig. 7.124 ).
The appearance of the Regulator configuration window in both cases looks the same.
Fig. 7.123. Configuration diagram of the Controller using Controller Menu
207
CONTROLLER 2
Autotuning coeff.
SP4
FB4
CONTROLLER 1
Autotuning coeff.
SP3
FB3
step 1
step 2
CONTROLLERS MENU
CHANNEL 1
Mode: Controller
SP1
FB1
LOGICAL CHANNEL MENU
Controller num. 2
Config.
CHANNEL 2
Mode: Controller
SP2
FB2
Controller num. 2
Config.
CHANNEL 3
Mode: Controller
SP3
FB3
Controller num. 1
Config.