User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
7.8.11.9. Application of Logical channel in the Profile/timer mode
See also:
Chapter 7.12. PROFILES/TIMERS
Task:
Create the Profile/timer in the logical channel 1 in the edge (once) triggering mode.
The trigger source is the logical channel 2 which is connected to the current input from UI4
module. The profile consists of 4 sections: 1. ramp from 0 to 10 in 5 seconds, 2. constant
value 8 in 2 seconds, 3. ramp from 8 to 4 in 3 seconds and 4. constant value 4 in 1 seconds.
The idle value is 0 and looping is disabled.
Solution:
First configure the device as follows. Then connect the current converter to the UI4
Appendices 8.2. UI4, UI8, UI12, U16, U24, I16,
I24 – VOLTAGE and CURRENT MEASUREMENT MODULES
Fig. 7.79. Example of Profile waveform
For the logical channel in the Profile/timer mode:
–
touch the screen and press the
Menu
button,
–
press the
Device configuration
button,
–
enter the
Logical channels
menu,
–
using the arrows in the top navigation bar, select any
logical channel
such as 1,
–
in the
Name
parameter write
Profile
,
–
Mode
parameter set as
Profile/timer
,
–
Source
parameter set as
P/T1:”Profile 1”
,
–
press the
Configure source
button,
•
Mode
parameter set as
edge (once)
,
•
Triggering source
parameter set as
Log.ch.2
,
•
in the
Idle value
parameter write
0
,
•
press the
Section list
button,
◦
press the green button at the bottom left side of the screen,
◦
Section num.
parameter should be set as
1
,
–
in
Duration
parameter write
0
,
–
Unit
parameter set as
second
,
144
0
2
4
6
8 10 12
0
2
4
6
8
10
12
Time [s]
V
a
lu
e
