Simex MultiCon CMC-99/141, User Manual

Page: 191 / 332

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
Fig. 7.108. Sample of Profile/timer with description of parameters
7.12.2. Profiles/timers - Triggering mode: level (gate), edge (once), edge (retrig.)
The
Profiles/timers
parameters for triggering mode: level (gate), edge (once), edge (retrig.)
are:
– Name – it gives the name to the Profile,
– Triggering mode – selects a way to generate a Profile/timer, there are five modes of
triggering:
•
disabled ,
•
level (gate)
– this means that the Profile configured by the user when
the source signal has the value
> 0
, otherwise (if source value
≤ 0
) the defined
Profile will not be generated. See Fig. 7.109 and example a) in Fig. 7.110 ,
• edge (once) – this means that the Profile configured by the user will be
triggered by the rising edge (from values ≤ 0 to the value > 0 ) of the source
signal. After the rising edge the Profile will be generated in whole (once),
regardless of further changes to the signal source, see
Fig. 7.109
and example
b)
in
Fig. 7.110
,
• edge (re-triggering) – this means that the Profile configured by the user will be
triggered by the rising edge (from values ≤ 0 to the value > 0 ) of the source
signal. However, in this mode, unlike the edge (once) mode the defined Profile
will be generated from the beginning every time the
Triggering source
signal
generates an edge, whether that Profile had been completed or not. See
Fig. 7.109
and example
c)
in
Fig. 7.110
,
– Triggering source – allows to choose a triggering source of the Profile/timer from
the logical channel list,
– Idle value – the value which occurs at the idle state which means before and after
generating the Profile/timer,
– Section list – the submenu in which the user can define up to 100 sections
generated by the Profile/timer. For more information see
Chapter 7.12.1.
Profile/timer - General settings
,
– Looping – each Profile/timer has an ability to repeat its generated signal, this
parameter has the following options:
•
disabled – the profile is not repeated,
• counted – allows to generate the profile a specified number of times defined in
the
Loop count
parameter,
191
Idle value
1
2
3
4
5
6
2
3
4
5
6
Legend:
2
1
Section for Profile without looping
Section for Profile with looping -> Return to position 1 (slope)
Section for Profile with looping -> Return to position 2 (const. value)
Time
1
1
2
3
4
5
6
Final value for
first section