Siemens SINAMICS G120P, Operating Instructions Manual

Page: 445 / 496

Alarms, faults and system messages
9.5 List of alarms and faults
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
445
9.5 List of alarms and faults
Axxxxx Alarm
Fyyyyy: Fault
Table 9- 6 Faults that can be acknowledged only by switching the inverter off and on again (POWER ON)
Number Cause Remedy
F01000 Software fault in CU Replace CU.
F01001 Floating-point exception Switch CU off and on again.
F01015 Software fault in CU Upgrade firmware or contact technical support.
F01018 Power-up aborted more than once After this fault is output, the inverter powers up with the factory settings.
Remedy: Back up factory setting with p0971=1. Switch CU off and on
again. Recommission the inverter.
F01040 Parameters must be saved Save parameters (p0971).
Switch CU off and on again.
F01044 Loading of memory data card de-
fective
Replace memory card or CU.
F01105 CU: Insufficient memory Reduce number of data records.
F01205 CU: Time slice overflow Contact technical support.
F01250 CU hardware fault Replace CU.
F1257 Firmware obsolete Upgrade the firmware in the CU.
F01512 An attempt has been made to
establish a conversion factor for
scaling which is not present
Create scaling or check transfer value.
F01662 CU hardware fault Switch CU off and on again, upgrade firmware, or contact technical sup-
port.
F30022 Power Module: Monitoring V
CE
Check or replace Power Module.
F30052 Incorrect Power Module data Replace Power Module or upgrade CU firmware.
F30662 CU hardware fault Switch CU off and on again, upgrade firmware, or contact technical sup-
port.
F30664 CU power up aborted Switch CU off and on again, upgrade firmware, or contact technical sup-
port.
F30850 Software fault in Power Module Replace Power Module or contact technical support.
F30950 Software fault in Power Module Replace Power Module or contact technical support.