Siemens SINAMICS G120P, Operating Instructions Manual

Page: 316 / 496

Operation
6.10 Operation with the IOP
Inverter cabinet units
316
Operating Instructions, 12/2014, A5E32923362A
Drive enable signals
The "Drive enables" screen shows a list of all current enable
signals of the inverter. It will be selected if the enable signal is
available and active ( ). The selection will be withdrawn if the
enable signal is not present and not active ☐.
This is only an information screen in which no changes can be
made.
6.10.4.3 Parameters
"Parameters" menu
Note
IOP function support
•
The actual menu structure and the function scope of the IOP depend on the following
factors:
– Type of Control Unit to which the IOP is connected
– Firmware version of the Control Unit
– Firmware version of the IOP
– Selected function group filtering of the parameters
•
When parameters or search values are changed, it is possible to change individual digits
or the complete value. Pressing the navigation wheel for a longer time (> 3 seconds)
switches between the two different change modes.
The "Parameters" menu allows you to access all inverter pa-
rameters, and therefore the associated comprehensive func-
tions. When this option is selected, parameter-based functions
are performed.
These are grouped as follows:
• Parameter groups
•
Search for number
• My parameters
•
Changed parameters
• Parameter filter