Siemens SINAMICS G120P, Operating Instructions Manual

Page: 181 / 496

Operation
6.3 Communication via PROFINET
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
181
6.3.5 Activating diagnostics via the control
The inverter provides the functionality to transfer fault and alarm messages (diagnostic
messages) to the higher-level controller according to the PROFIdrive error classes.
The functionality must be selected in the higher-level controller and activated by powering up.
6.3.6 Identification & maintenance data (I&M)
I&M data
The inverter supports the following identification and maintenance (I&M) data.
I&M
data
Format Explanation Associated
parameters
Example for the
content
I&M0 u8[54] PROFINET Inverter-specific data, read only - See below
I&M1 Visible String [32] Plant/system identifier p8806[0 … 31] "ak12-
ne.bo2=fu1"
Visible String [22] Location code p8806[32 … 53] "sc2+or45"
I&M2 Visible String [16] Date p8807[0 … 15] "2014-05-21
12:15"
I&M3 Visible String [54] Any comment p8808[0 … 53] -
I&M4 Octet String[54] Test signature for tracking
changes for Safety Integrated -
this value has no significance for
SINAMICS G120P Cabinet
This value can be changed by
the user.
The test signature is reset to the
value generated by the machine
is p8805 = 0 is used.
p8809[0 … 53]
When requested, the inverted transfers its I&M data to a higher-level control or to a PC/PG
with installed STEP 7, STARTER or TIA-Portal.