Siemens SINAMICS G120P, Operating Instructions Manual

Page: 247 / 496

Operation
6.8 Communication via RS485
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
247
Binary value Objects
Instance
ID
Object name Description Possible values Text active Text
inactive
Access
type
Parameter
BV0 RUN/
STOP ACT
Inverter status regardless of
command source
RUN / STOP STOP RUN R r0052.2
BV1 FWD / REV Direction of rotation regard-
less of command source
REV / FWD FWD REV R r0052.14
BV2 FAULT ACT Inverter fault FAULT / OK FAULT OK R r0052.3
BV3 WARN ACT Inverter warning WARN / OK WARN OK R r0052.7
BV4 MANUAL/
AUTO ACT
Indicates the source of the
manual/auto inverter control
AUTO /
MANUAL
AUTO LOCAL R r0052.9
BV7 CTL
OVERRIDE
ACT
ACT displays the inverter's
control from the BACnet over-
ride control via BV93.
Note that the operator panel's
"Manual" operating mode has
a higher priority than the
BACnet override control.
ON/OFF 0 1 R r2032[10]
BV8 AT SET-
POINT
Setpoint reached YES / NO YES NO R r0052.8
BV9 AT MAX
FREQ
Maximum speed reached YES / NO YES NO R r0052.10
BV10 DRIVE
READY
Inverter ready YES / NO YES NO R r0052.1
BV15 RUN COM
ACT
ACT indicates the status of
the ON command, regardless
of the source
YES / NO 0 1 R r2032[0]
BV16 HIB MOD ACT ACT means that the inverter
is operating in energy-saving
mode
ON/OFF 0 1 R r2399[1]
BV17 ESM MOD ACT means that the inverter
is operating in the essential
service mode
ON/OFF 0 1 R r3889[0]
BV20 RUN/
STOP CMD
ON command for the inverter
(when controlling via BACnet)
RUN / STOP 0 1 C r0054.0
BV21 FWD/
REV CMD
Reverse direction of rotation
(when controlling via BACnet)
REV / FWD 0 1 C r0054.11
BV22 FAULT
RESET
Acknowledge fault (when
controlling via BACnet)
RESET / NO 0 1 C r0054.7
BV24 CDS Local / Remote Local / Remote YES NO C r0054.15
BV26 RUN ENA
CMD
Enable inverter operation ENABLED DISABLED C r0054.3
BV27 OFF2 OFF2 status RUN / STOP 0 1 C r0054.1
BV28 OFF3 OFF3 status
Note:
BV28 sets the r0054.4,
r0054.5, and r0054.6 bits
RUN / STOP 0 1 C r0054.2