Siemens SINAMICS G120P, Operating Instructions Manual

Page: 33 / 496

Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
33
Mechanical installation
3
3.1 Section content
This chapter provides information on the following:
● The conditions for transporting, storing, and installing the cabinet unit
● Preparing and installing the cabinet unit
3.2 Transport, storage
Transportation
WARNING
Danger to life due to improper transporting of the unit
The unit can tip over if you transport it incorrectly – or if you use transport equipment that is
not permitted for the purpose. This can result in death, serious injury or material damage.
•
Ensure that only trained personnel transport the device with approved transport
equipment and lifting tools.
•
Observe the center of gravity specifications. A label or stamp is attached to each
transportation unit and precisely shows the center of gravity of the cabinet.
• Transport the unit only in the original marked upright position. Do not tilt the device or
allow it to fall.
•
The forks of the truck must protrude at the rear of the transport pallet. The floor panels
of the transport units do not support loading.
WARNING
Danger to life through the use of non-approved fork-lift trucks
If the forks are too short, this can cause the transport unit/cabinet to tip over resulting in
death, serious injury, or damage to the cabinet.
• The forks of the truck must protrude at the rear of the transport pallet. The floor panels
of the transport units do not support loading.
•
Only use fork-lift trucks approved for this purpose to transport the units.