Ross SYNERGY 4000DR-003, Operation Manual, Page: 80 / 332

4–2 • Switcher Basics Synergy Series Operation Guide (v18)
Before Starting
If you are unfamiliar with the operation of a multi-level effects switcher, it is always advisable to
check the initial condition of the switcher’s control panel, and reset the panel if required. By
performing a software reset, you can guarantee a base default condition, and eliminate any special
setups that may be present on the panel (as left by the last TD). Two reset methods are provided below
for all Synergy switchers.
Software Reset
This section includes information for resetting your Synergy switcher:
• Using the buttons in the Global Memory Group of the Synergy control panel
• Using the Synergy menu system
Control Panel Method
Use the following method to perform a full software reset:
• Simultaneously press
ALL
(in the RECALL column) and
ALL
(in the STORE column)
of the Global Memory Group .
Refer to the section “ Resetting the System ” on page 2–19 for additional information.
Menu Method
Use the following procedure to perform a full software reset using the Synergy menu system:
1. Navigate to the Installation Menu 2-2 as follows:
• Press
HOME B MORE B Setup B Installation B MORE
.
2. Press
Recall Factory
to display the Recall Factory Menu 1-2 .
Recall Factory Menu
3. Press
Switcher
to restore Switcher Registers (control panel settings) to their default
values. The Reset Switcher Warning Screen is displayed.