Ross SYNERGY 4000DR-003, Operation Manual, Page: 197 / 332

Synergy Series Operation Guide (v18) Keying • 7–23
Auto Key Setup Menu — Clip and Gain Unlocked
• Adjust clip and gain in one of two places:
~
To adjust clip level, use the top knob in the Display Section or the
CLIP
knob
in the Effects Control Section .
~ To adjust gain (softness), use the middle knob in the Display Section or the
GAIN
knob in the Effects Control Section
Refer to the section “ Auto Select Key Operating Tips ” on page 7–24 for instructions
on re-storing new clip and gain settings for an Auto Select key.
6. If desired, adjust transparency as follows:
• Toggle the Transparency button to On .
• Use the Transparency knob to adjust transparency from opaque (0%) to fully
transparent (100%).
7. If desired, change the priority of the two keyers as follows:
• Toggle the Key Over button between On and Off to change the priority of the two
keyers:
~
On — Select this option to change the priority to Key 1 , setting it over
(visually on top of) Key 2 . The KEY OVER button in the MLE Key 1 Group
will now be lit.
~ Off — Select this option to keep the priority as Key 2 over Key 1 . This is the
default setting.
8. Select and adjust additional key modifiers as desired, using the controls in Key
Modifier Sections 1 and 2 . Modifiers include:
• MATTE FILL
• KEY INV
• MASK
• FLY KEY
• Border Effects
Refer to the section “ Using Key Modifiers ” on page 7–49 for details.
9. If desired, preview the key by pressing KEY PV .
Note
To return the clip and gain values to the default settings of 49.0% and
81.9% respectively, press the
Make Key Linear softkey.
If you turn
KEY MEM
back on again, the previously stored values are
recalled from memory.