Ross SYNERGY 4000DR-003, Operation Manual, Page: 260 / 332

8–18 • Memory Functions and More Synergy Series Operation Guide (v18)
Notes on the Memory Lock Function
Please note the following important points regarding the Memory Lock function:
• If you attempt to store into a locked register, the keypad flashes and the keypad display
indicates
Memory [n] LOCKED
. Press any button on the keypad to stop the flashing.
• If you lock a memory register, it is locked for all memory groups on the entire switcher.
• A locked memory register will be overwritten when a register is recalled from a storage
device such as a floppy disk or USB key.
• When you store to and recall from a storage device, the Memory Lock attribute is stored
and recalled along with the register and its contents.
• When you recall an individual memory from a storage device to a locked memory
location on the switcher, you are prompted to cancel or proceed.
• The status of registers locked or unlocked also appears on the Name Memories Menu .
Memory Lock Using the Name Memories Menu
The Name Memories Menu is used to name any of the 100 available memory registers (on an
individual MLE basis), and change the Lock/Unlock status of each register or bank of registers. This
menu also allows you to view the current register, the selected MLE, the current name and the
Lock/Unlock status of the register or bank.
Use the following procedure to enable and disable Memory Locks using the Name Memories Menu :
1. Navigate to the Name Memories Menu as follows:
• Press HOME B Attributes B Memories Setup .
Name Memories Menu
2. Select the memory register you want to lock or unlock as follows:
• Use the MLE knob to select the MLE on which you want to change the
Lock/Unlock status of a Register.
• Use the Bank knob to select the Bank and Register that you want to change.
3. Toggle Locked Yes/No to the desired mode, either locked ( Yes ) or unlocked ( No ).
The selected mode is displayed in the Register Status Display .
4. Repeat to change additional registers.
Operating
Tip
Press
Lock Bank
to lock all the memories in the currently selected
bank. For example, when (00) is selected, pressing
Lock Bank
will
lock all registers from (00) to (09) and
Yes
will be highlighted under
Locked
for each of the registers within the bank. Pressing
Unlock
Bank
will remove the lock from the registers within the bank.