Ross SYNERGY 4000DR-003, Operation Manual, Page: 150 / 332

5–18 • Background Transitions Synergy Series Operation Guide (v18)
• The Key Over function can be regarded as a fourth “next transition”, which is mutually
exclusive with the
BKGD
,
KEY 1
, and
KEY 2
buttons. When
KEY OVER
is pressed,
all three “next transition” buttons automatically turn off.
Refer to the section “ DVE Send and Keying ” for additional details on the
KEY OVER
button, when
used in conjunction with the DVE Send feature.
Transition Limit
The TRANS LIMIT (transition limit) button located in the MLE Transition group allows you to stop
a transition at a preset position — in between the two absolute Fader limits.
Use the following procedure to perform a transition limit effect:
1. Ensure that the correct MLE is selected in the Preview Bus group.
2. Move the Fader to an upper or lower limit, and note the limit that you choose. The
Fader must be returned to this limit in a subsequent step.
3. Select a Dissolve, Wipe, or DVE Send as your next transition.
4. Move the Fader , and manually set the transition to the desired position.
• In the case of a dissolve, visually set the desired mix (superimposition) between
Program and Preset.
• In the case of a wipe, visually set the desired position between Program and Preset.
• In the case of a DVE Send, visually set the desired position or mix
(superimposition) between Program and Preset.
5. Leave the Fader at its preset position, and press TRANS LIMIT . The button lights
momentarily , and the fader position is stored.
6. Move the Fader back to the limit selected in step 2.
7. Press TRANS LIMIT to turn on the Transition Limit function.
8. Use the AUTO TRANS button to perform the transition. The transition moves to the
limit that you selected in step 4, and stops.
9. There are two ways to continue the transition:
• Leave the TRANS LIMIT button turned on. When you use the AUTO TRANS
button again, the transition reverses — and returns to its starting point.
• Turn off the TRANS LIMIT button. When you use the Fader or AUTO TRANS
again, the transition continues to the full Preset Bus source.
This completes the procedure to perform a transition limit effect.