Rohde & Schwarz 1424.7805K02, User Manual

Page: 346 / 530

Remote control commands
R&S
®
NRX
346 User Manual 1178.5566.02 ─ 09
Parameters:
<value>
If the entered filter length is not a 2 n value, the value is rounded
to the next 2
n
value without an error message.
Range: 1 to 65536
*RST: 4
Manual operation: See "Filter Length" on page 123
CALCulate<Measurement>[:CHANnel<Channel>]:TRACe:AVERage:TCONtrol:
AUTO <state>
Effective for trace measurements.
Enables or disables the automatic termination control. See also
CALCulate<Measurement>[:CHANnel<Channel>]:TRACe:AVERage:
TCONtrol[:ENUM]
on page 346.
Suffix:
<Measurement>
.
1 to 8
Measurement
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<state> *RST: ON
Manual operation: See "Moving Average State" on page 125
CALCulate<Measurement>[:CHANnel<Channel>]:TRACe:AVERage:TCONtrol[:
ENUM] <mode>
Effective for trace measurements.
Defines how the measurement results are output. This is called termination control.
Suffix:
<Measurement>
.
1 to 8
Measurement
<Channel> 1 to 2
1 = primary sensor, 2 = secondary sensor
Parameters:
<mode> MOVing | REPeat
If you use
SYSTem:PRESet
instead of
*RST
, the RST value dif-
fers. See Table 13-17 .
MOVing
Outputs intermediate values to facilitate early detection of
changes in the measured quantity. In the settled state, that
means when the number of measurements specified by the
average count has been performed, a moving average is output.
Configuring sensors