Rohde & Schwarz 1424.7805K02, User Manual

Page: 224 / 530

Remote control commands
R&S
®
NRX
224 User Manual 1178.5566.02 ─ 09
CALCulate<Measurement>:LIMit<DirectionalChannel>:LOWer[:DATA]:POWer
<value>
Sets the lower limit for the measured power values.
If you enter a value without unit, the unit is defined by
UNIT<Measurement>:
POWer[:VALue]
. For further information, see Chapter 13.6.1.3, "Units" , on page 217.
Suffix:
<Measurement>
.
1 to 8
Measurement
<DirectionalChannel> 1 to 2
1 = primary sensor, 2 = secondary sensor or 1 = forward, 2 =
reflection (reverse)
Parameters:
<value> Range: -120.0 to +150.0
*RST: -60.0
Default unit: dBm
Manual operation: See "Lower Limit" on page 59
See "Forward Lower Limit, Reflection Lower Limit" on page 61
CALCulate<Measurement>:LIMit<DirectionalChannel>:LOWer:STATe <state>
Enables or disables the monitoring function for the lower limit.
Suffix:
<Measurement>
.
1 to 8
Measurement
<DirectionalChannel> 1 to 2
1 = primary sensor, 2 = secondary sensor or 1 = forward, 2 =
reflection (reverse)
Parameters:
<state> *RST: OFF
Manual operation: See "Lower Limit State" on page 59
See "Forward Lower Limit State, Reflection Lower Limit State"
on page 60
CALCulate<Measurement>:LIMit<DirectionalChannel>:UPPer[:DATA] <value>
Sets the upper limit for the measured values.
Suffix:
<Measurement>
.
1 to 8
Measurement
<DirectionalChannel> 1 to 2
1 = forward, 2 = reflection (reverse)
Measurement settings and results