Rohde & Schwarz 1424.7805K02, User Manual

Page: 24 / 530

Getting started
R&S
®
NRX
24 User Manual 1178.5566.02 ─ 09
3.1.10 Switching on or off
Table 3-1: Overview of power states
Status LED Position of power switch
Off Off [0]
Standby
orange
[I]
Ready
green
[I]
To switch on the product
The product is off but connected to power.
1. Set the switch on the power supply to position [I]. See Chapter 3.2.2.5, "AC supply
and power switch" , on page 30.
The LED of the [standby] key is orange. See Chapter 3.2.1.6, "On/standby key" ,
on page 29.
2. Press the [standby] key.
The LED changes to green. The product boots.
See
Chapter 4.1.1, "Start dialog" , on page 33.
If the previous session ended regularly, the product uses the settings from the last
session.
3. If you want to return to a defined initial state, perform a preset.
See "Preset" on page 135.
To shut down the product
The product is in the ready state.
► Press the [standby] key.
The operating system shuts down. The LED changes to orange.
To disconnect from power
The product is in the standby state.
1.
NOTICE! Risk of data loss. If you disconnect the product from power when it is in
the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
The LED of the standby key is switched off.
2. Disconnect the product from the power source.
Further information:
●
Chapter 8, "Saving and recalling settings" , on page 134
●
Chapter 3.2.1.6, "On/standby key" , on page 29
Preparing for use