Pacific Power Source AFX Series, Operation Manual

Page: 264 / 485

AFX SERIES® OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 264 of 485
Command Syntax [SOURce:]RANGe
Description Selects high or low voltage range. Although the AFX Series® has only
a single voltage range, this commands allows simulation of a dual
range AC voltage source which is more familiar to some users.
Despite this virual low range capability, no actual physical range
change takes places so the output is never interrupted.
Note: When switching from HIGH to LOW range, the output voltage
may be reduced to the highest available voltage on the low range.
Parameters < 0 | LOW | 1 | HIGH >
Parameter Format <b>
Example RANG HIGH
Query Format [SOURce:]RANGe?
Returned Data Format <b>
Query Example RANG?
1
Command Syntax [SOURce:]RAMP#
Description Sets voltage slew rate for selected phase number or for all phases if
no phase number is specified.
Parameters Slew rate
Parameter Format <nr2>
Example SOUR:RAMP3 10.5
Query Format [SOURce:]RAMP#?
Description Returns voltage slew rate setting for specified phase (1, 2 or 3) or for
phase 1 (A) if no phase number is specified.
Returned Data Format
Query Example SOUR:RAMP3?
10.5000
Command Syntax [SOURce:]UPDATEPHase
Description Set the phase angle at which programmed voltage changes on phase
A will take place. This applies to output on and off phase angle
placement as well. Available range is from 0° through 360.0°
inclusive. Values higher than 360.0° will be truncated to 360.0000°
automatically.
Parameters < 0.0000 - 360.0000 >
Parameter Format <nr2>
Example UPDATEPH 90.00
Query Format [SOURce:]UPDATEPHase?
Returned Data Format <nr2>
Query Example SOURce:UPDATEPH?
90.0000