Pacific Power Source AFX Series, Operation Manual

Page: 226 / 485

AFX SERIES® OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 226 of 485
Command Syntax MEASure:LOGger:STOP
Description Stops the logging process that was started with
MEASure:LOGger:START.
Parameters None
Parameter Format n/a
Example MEAS:LOG:STOP
Query Format None
Query Format MEASure:LOGger:STATe?
Description Returns the state of the measurement data logging process as a
number as follows:
0 – Stopped
1 – Running
2 – Paused
Returned Data Format <nr1>
Query Example MEAS:LOG:STAT?
1
Command Syntax MEASure:LOGger:LIMit <cr>
Description Sets the number of samples to get. Once the logging process reach
this limit it will stop.If the limit is set as OFF or 0 it will not stop unless
MEAS:LOG:STOP is executed.
The limit can be specified as a number of samples or in seconds if a
character “S” is added to the number. If the limit is passed as
seconds, the command will compute the number of samples based
on the logging rate. The formula is: number of samples = seconds /
rate.
The rate can be set with:
MEASure:LOGger:RATE <nr1>
or queried with:
MEASure:LOGger:RATE?.
Parameters < OFF | 0 >
XS where X is a time limit in seconds
X where X is the limit in number of samples
Parameter Format <cr>
Examples MEAS:LOG:LIM OFF
MEAS:LOG:LIM 20S
MEAS:LOG:LIM 100
Query Format MEASure:LOGger:LIMit?
Returned Data Format 0
Query Example MEAS:LOG:LIM?
10000