Pacific Power Source AFX Series, Operation Manual

Page: 467 / 485

AFX SERIES® OPERATION MANUAL
SECTION 13:
Service and Maintenance
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 467 of 485
Error Source Code Category Error Message Possible Cause Resolution
Primary Fault 212 Error AC input: voltage is below
minimum.
Primary Fault 213 Error AC input: missing phase.
Primary Fault 214 Error PFC DC bus voltage
regulation lost.
Primary Fault 215 Error PFC DC bus voltage limit
exceeded. CLA OVP Trip
Primary Fault 216 Error Temperature 1 protection
(input stage)
AC Input Stage heatsink
temperature exceeded
maximum limit.
Check for possible air
flow obstructions and
ambient temperature
Primary Fault 217 Error Temperature 1 protection
(input stage)
AC Input Stage heatsink
temperature exceeded
maximum limit.
Check for possible air
flow obstructions and
ambient temperature
Primary Fault 218 Error Temperature 2 protection
(PFC/LLC)
PFC and DC/DC Converter
heatsink temperature
exceeds maximum limit.
Check for possible air
flow obstructions and
ambient temperature
Primary Fault 219 Error Temperature 2 protection
(PFC/LLC)
PFC and DC/DC Converter
heatsink temperature
exceeds maximum limit.
Check for possible air
flow obstructions and
ambient temperature
Primary Fault 220 Error Temperature 3 protection
(PFC/LLC)
PFC and DC/DC Converter
heatsink temperature
exceeds maximum limit.
Check for possible air
flow obstructions and
ambient temperature
Primary Fault 221 Error Temperature 3 protection
(PFC/LLC) exceeded
minimum limit.
PFC and DC/DC Converter
heatsink temperature
exceeds minimum limit.
Primary Fault 222 Error Temperature 4 protection
(main transformer)
High Frequency
Transformer temperature
exceeds maximum limit.
Check for possible air
flow obstructions and
ambient temperature
Primary Fault 223 Error Temperature 4 protection
(main transformer)
High Frequency
Transformer temperature
exceeds minimum limit.
Primary Fault 224 Error Internal bias supply fault. Internal Bias Supply fault
occurred
Check for correct AC
input voltage connection.
Primary Fault 226 Error Hardware does not match
input voltage setting.
Incorrect AC input voltage
detected
Check for correct AC
input voltage rating.
Primary Fault 227 Error Primary capacitor board
not detected.
An inconsistency was
detected in the power
source's internal
communication network.
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Primary Fault 228 Error Invalid node ID. Run unit
discovery to recover.
An inconsistency was
detected in the power
source's internal
communication network.
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Primary Fault 229 Error Incorrect DSP type
detected. Cycle-power to
re-try.
Unable to detect correct
DSP type.
Try cycling AC input
power.
Primary Fault 230 Error PFC output current peak
protection.
PCF stage output current
exceeded maximum peak
level.
Possible overload on one
or more output inverters.
Primary Fault 231 Error PFC output current slow
protection
Primary Fault 232 Error AC input: voltage is above
maximum.
Incorrect AC input voltage
detected
Check for correct AC
input voltage rating.