Pacific Power Source AFX Series, Operation Manual

Page: 307 / 485

AFX SERIES® OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 307 of 485
Command Syntax [SOURce:]STEP:VOLTage[:AC][:INITial]# < nr2 >, <cr>
[SOURce:]STEP:VOLTage[:AC][:INITial]#
Voltage phase A, OPT: Voltage phase B, OPT: Voltage phase C, OPT
Description This command sets the initial STEP voltage for selected phase # or for
all phases if phase reference is omitted.
Note: If you get the following error, check the STEP:MODE setting as the
parameter you are trying to program is the depending one.
Execution error: Not allowed command with the current
configuration.
Either set one of the othe STEP parameters or change the MODE.
Note: If you get this error, check the min or max range for this parameter.
Parameter above maximum unit scope.
Parameters Voltage , < NORmal | SATurate >
Default is NORmal if optional second parameter is omitted.
Parameter Format <nr2>, <cr>
Example STEP:VOLT1 230.00, SAT
Query Format
[SOURce:]STEP:VOLTage[:AC][:INITial]#?
Returned Data Format <nr2> | <nr2>,<nr2>,<nr2>
Query Example STEP:VOLT1?
230.0000
Query Syntax [SOURce:]STEP:VOLTage[:AC][:INITial]#:MINimum?
Description This command returns the minimum permissible set value for the
initial STEP voltage for selected phase # or for all phases if phase
reference is omitted
Returned Data Format <nr2>
Query Example STEP:VOLT1:MIN?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
Query Syntax [SOURce:]STEP:VOLTage[:AC][:INITial]#:MAXimum?
Description This command returns the maximum permissible set value for the
initial STEP voltage for selected phase # or for all phases if phase
reference is omitted
Returned Data Format <nr2>
Query Example STEP:VOLT1:MAX?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
Query Syntax [SOURce:]STEP:VOLTage[:AC][:INITial]#:DEFault?
Description This command returns the default set value for the initial STEP
voltage for selected phase # or for all phases if phase reference is
omitted
Returned Data Format <nr2>
Query Example STEP:VOLT1:DEF?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings