Neoware t5730 - Thin Client, User Manual

Page: 169 / 506

Setup Menus
HP 700-92/96 Settings 147
LineTx (D)
Factory default: Unchecked
The setting of this option determines whether data is sent a line or a
page at a time when in Edit mode.
When this option is checked, data will be transmitted a line at a time.
When unchecked, data will be transmitted a page at a time. Page
data will either be from the beginning of display memory or from the
current cursor position.
InhHndShk (G)
InhDC2 (H)
Factory default: Unchecked
The combined setting of these two options determine the type of
handshaking used when blocks of data are transmitted to the host.
One of three types of handshake may be used:
1 No handshake. Blocks of data are sent immediately when the
relevant transmit key is pressed.
2 DC1 handshake. Data is only sent to the host when the host
sends an ASCII
DC1 control code to request it.
3
DC1/DC2/DC1 handshake. The host sends an ASCII DC1 con-
trol code, to which TeemTalk replies by sending a DC2 code if
ready to transmit. The host sends the DC1 code again to cause
the data block to be transmitted.
The type of handshake used for block transfers is determined by the
type of block transfer to be performed, the mode that the HP70092
emulation currently operating in (character, block line, block page,
or modify mode), and the setting of these two options.
The setting of these two options will have the following general
effect:
InhHndShk
only selected:
The DC1/DC2/DC1 handshake or no handshake
will be used.