4-46 Installing the Operating System and Utilities
Installing the Agent Software
To install Agent software, you need to know the hardware model (such as Express5800/120Mf) and
the destination directory for Agent software and DMI 2.0 software.
1.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive.
2.
Click on [Setup] on the EXPRESSBUILDER Master Control menu, and select [ESMPRO]
from the pop-up menu appeared.
3.
ESMPRO Setup will be displayed. Click on [Agent].
4.
Enter the requested information when prompted. A progress gauge displays the names of
the files being loaded and the percentage of completed installation.
IP Address Confirmation
If you have a problem with installation, confirm that the cabling is connected correctly. Also,
verify that the IP address is correct as follows.
1.
In the Main group, double-click the Command prompt icon to get to the Command prompt.
2.
Enter the following command, where xxx.xxx.xx.x is the system IP address.
ping xxx.xxx.xx.x
If TCP/IP is set up correctly, your screen will display four lines similar to the following.
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
Reply from xxx.xxx.xx.x: bytes=32 time<10ms TTL=32
If TCP/IP is not set up correctly, your screen will display four lines similar to the
following.
Request timed out.
Request timed out.
Request timed out.
Request timed out.
If your system displays an invalid destination message, check the cabling and IP address
assigned before continuing.
Using the ESMPRO Agent
For using the ESMPRO Agent and other explanations on ESMPRO, refer to the online document in
the EXPRESSBUILDER CD-ROM.
Summary of Contents for EXPRESS5800/120MF
