NEC EXPRESS5800/120MF, User Manual

Page: 123 / 346

Configuring Your System 3-25
Option Parameter Description Your Setting
Service Partition
Type – Indicates the type of the service
partition.
Assert NMI on
PERR Disabled
[Enabled] Indicates whether PCI PERR is
supported or not.
Assert NMI on
SERR Disabled
[Enabled] Indicates whether PCI SERR is
supported or not.
FRB-2 Policy Disable FRB2 Timer
[Disable BSP]
Do not Disable BSP
Retry 3 Times Set this item to "Disable BSP."
Boot Monitoring [Disabled]
5 minutes
10 minutes
15 minutes
20 minutes
25 minutes
30 minutes
35 minutes
40 minutes
45 minutes
50 minutes
55 minutes
60 minutes Disables or enables the boot
monitoring feature. Set to disabled
when installing OS. Once OS is
installed, re-enable.
To use this function, install NEC
ESMPRO Agent. Do not use this
function if the system is booted
from the OS without installation of
NEC ESMPRO Agent or CD-ROM.
Set this item to "Disabled" if
ARCServe uses the Disaster
Recovery Option.
Boot Monitoring
Policy [Retry 3 times]
Retry Service Boot
Always Reset Indicates the policy when the timer
expired on booting.
Thermal Sensor Disabled
[Enabled] Enables or disables temperature
sensor monitoring feature.
BMC IRQ Disabled
5
10
[11] Sets the BMC IRQ.
Post Error Pause Disabled
[Enabled] Specifies whether the system waits
for user intervention on critical
POST errors or not.
AC-LINK Stay Off
[Last State]
Power On
Sets the AC-LINK feature.
Determines the mode of operation
if a power loss occurs. (See the
table below.)
[ ]: Factory-set
The table below lists how selections for "AC-LINK" determine the power status of the server when
the power supply to the server restarts.
Parameter
State before powered off
Stay Off Last State Power On
In service Off
On On
Out of service (DC power: Off) Off
Off On
Forced shutdown * Off
Off On
* Pressing the POWER switch for at least four seconds shuts down the power to the server.