![background image](http://html.mh-extra.com/html/nec/express5800-120mf/express5800-120mf_user-manual_251193169.webp)
Installing the Operating System and Utilities 4-29
11.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the main unit. Insert
the floppy disk storing the setting information (CSL_LESS.cfg) into the floppy disk drive.
12.
Connect the management PC specified as the report destination to LAN.
13.
Turn off the power of the main unit and then on again to restart the system.
After a single reboot, the main menu appears on the screen of the management PC to allow
the hardware setup and several utilities to be run from the management PC.
NOTE:
The main menu appears without rebooting when setup information
(CSL_LESS.CFG) inside the floppy disk is already established.
14.
When the main menu appears on the screen of the management PC, remove the floppy disk
from the floppy disk drive.
Running EXPRESSBUILDER from the Management PC via Direct Connection (COM B)
Use the following procedures to run EXPRESSBUILDER from the management PC connected
directly to serial port B (COM B) on the main unit. Refer to the MWA First Step Guide for details of
MWA.
1.
Install MWA in the management PC.
2.
Select [Environment] and [Direct Connection Setting] sequentially from the [File] menu of
MWA to display the [Direct Connection] dialog box. Then provide the following setting:
<Direct Connection>
Port No.:
COM port on the management PC to be connected
Baud Rate:
19200
Flow Control:
RTS/CTS
3.
Select [Configuration] from the [File] menu of MWA to display the [Configuration] dialog
box.
4.
Select [New] to display the [Select a model (New)] dialog box.
5.
Check [Write data to FD]. Then select the model name to display the [Configuration for
BMC] dialog box.
6.
Set and register the configuration information including the computer name on the
[Configuration for BMC] dialog box and then write the information into the floppy disk
with the following file name:
<File name>
CSL_LESS.cfg
7.
Select the [Properties] command from the popup menu displayed by right-clicking on the
server name to display the [Properties] dialog box.
Summary of Contents for EXPRESS5800/120MF
