7-46 Upgrading your Server
Removal
Remove the DIMM using the following procedure.
NOTES:
!
To remove the failed DIMM, check the error message appearing in
POST or ESMPRO to identify the DIMM socket (group) in which the
failed DIMM is installed.
!
The server operates only when at least two DIMMs are installed.
1.
See the section
Preparing for Upgrade
described earlier to prepare.
2.
Remove the left-hand side access panel as described earlier in this chapter.
3.
Remove the top air duct.
4.
Open the levers at both sides of the socket from which you remove the DIMM.
The DIMM is unlocked and ready for removal.
5.
Reinstall all parts removed in Step 2 and 3.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, write down the message and see the POST error
messages listed in Chapter 6.
6.
Start the SETUP and select [Advanced]
→
[Memory Configuration]
→
[Memory Retest]
→
[Enabled] to clear the error information of the removed DIMM. (See Chapter 3 for
details.)
7.
Select "Yes" for [Reset Configuration Data] on the Advanced menu.
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
Summary of Contents for EXPRESS5800/120MF
