Motorola AP-7131 Series, Reference Manual

Page: 576 / 954

8 - 6 WiNG 5.5 Access Point System Reference Guide
TCP Intercept A SYN-flooding attack occurs when a hacker floods a server with a barrage of requests for
connection.
Because these messages have unreachable return addresses, the connections cannot be
established. The resulting volume of unresolved open connections eventually overwhelms
the server and can cause it to deny service to valid requests, thereby preventing legitimate
users from connecting to a Web site, accessing E-mail, using FTP service, and so on.
The TCP intercept feature helps prevent SYN-flooding attacks by intercepting and
validating TCP connection requests. In intercept mode, the TCP intercept software
intercepts TCP
synchronization (SYN) packets from clients to servers that match an
extended access list. The software establishes a connection with the client on behalf of the
destination server, and if successful, establishes the connection with the server on behalf
of the client and knits the two half-connections together transparently. Thus, connection
attempts from unreachable hosts will never reach the server. The software continues to
intercept and forward packets throughout the duration of the connection. The number of
SYNs per second and the number of concurrent connections proxied depends on the
platform, memory, processor, and other factors. In the case of illegitimate requests, the
software’s aggressive timeouts on half-open connections and its thresholds on TCP
connection requests protect destination servers while still allowing valid requests.
When establishing a security policy using TCP intercept, you can choose to intercept all
requests or only those coming from specific networks or destined for specific servers. You
can also configure the connection rate and threshold of outstanding connections.
Optionally operate TCP intercept in watch mode, as opposed to intercept mode. In watch
mode, the software passively watches the connection requests flowing through the router.
If a connection fails to get established in a configurable interval, the software intervenes
and terminates the connection attempt.
TCP Null Scan Hackers use the TCP NULL scan to identify listening TCP ports. This scan also uses a series
of strangely configured TCP packets, which contain a sequence number of 0 and no flags.
Again, this type of scan can get through some firewalls and boundary routers that filter
incoming TCP packets with standard flag settings.
If the target device's TCP port is closed, the target device sends a TCP RST packet in reply.
If the target device's TCP port is open, the target discards the TCP NULL scan, sending no
reply.
TCP Post SYN A remote attacker may be attempting to avoid detection by sending a SYN frame with a
different sequence number than the original SYN. This can cause an
Intrusion Detection
System (IDS) to become unsynchronized with the data in a connection. Subsequent frames
sent during the connection are ignored by the IDS.
TCP Packet Sequence This is an attempt to predict the sequence number used to identify the packets in a TCP
connection, which can be used to counterfeit packets. The attacker hopes to correctly guess
the sequence number used by the sending host. If successful, they can send counterfeit
packets to the receiving host which will seem to originate from the sending host, even
though the counterfeit packets may originate from some third host controlled by the
attacker.
TCP XMAS Scan The TCP XMAS Scan floods the target system with TCP packets including the FIN, URG, and
PUSH flags. This is used to determine details about the target system and can crash a
system.
TCP Header Fragment Enables the TCP Header Fragment denial of service check in the firewall.