Mindray Anesus ME7T, Operator'S Manual

Page: 176 / 312

12 - 2 Operator’s Manual
12 Display & Cine Review
3. Use the trackball/trackpad to shifting the image.
4. Adjust the magnification factor to 1.00 to exit pan zoom.
12.2.3 iZoom (Full-screen Zooming)
Perform the following procedure:
1.
Press the user-defined key for “iZoom” to zoom in the image.
The zooming area includes image area, parameter area, image banner, and so on.
2. Press the user-defined key again to zoom in the image area only.
The image goes to full-screen.
3. Press the user-defined key again to exit.
12.3 Freeze/Unfreeze the Image.
Press [Freeze] key on the control panel to freeze a scanning image. In freezing mode, the probe
stops transmitting acoustic power, and all images as well as the parameters are kept still.
After freezing an image, the system may enter cine review, measure, comment adding, or body
mark mode, which is dependent upon preset, see “4.1.2 General”.
Press <Freeze> in frozen mode to unfreeze the image, and the system continues image scanning.
12.3.1 Imaging Mode Switching When Frozen
Imaging mode switching in frozen mode follows the following principles:
•
In splitting display B mode, press <Dual>/user-defined key for “Quad” to switch among the
windows; press <B> to exit splitting display mode and enter the image of the currently
activated window in full screen.
• In frozen mode, the system supports imaging mode switching between the sub-modes (only for
the activated window). For example, if the frozen image is of B+C+PW mode, then the system
supports imaging mode switching between B+C+PW, B+C, B+PW and B by pressing <C> or
<PW>.
• The imaging mode and parameters of an unfrozen image is the same as the corresponding one
that before frozen; but the display format is the same as the one before unfrozen.
12.4 Cine Review
The system allows you to review and edit the images prior to the image frozen. This function is
called as cine review. The magnified images can also be reviewed, and the operating method is the
same. You can perform zoom, measurements, add comments and body marks on the images being
reviewed.
The system supports manual review as well as automatic review. The default setup is Manual Cine,
but you can switch between Auto Cine and Manual Cine.
In addition, the system supports the images reviewed along with physiological unit waveforms, if
the detection of physiological unit waveforms is performed.
CAUTION
• The cine memory must be cleared at the end of the current patient and the
onset of the next new patient by tapping [End].