![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387283.webp)
REPAIR INSTRUCTIONS
Page 267
Air Compressor Installation
[261 CK]
Refer to Figure 295.
If the compressor drive coupling has been
removed or a replacement compressor is being
installed, air compressor coupling holder tool
J 41071 will be required to hold the compressor
shaft while the coupling nut is being torqued.
Torque coupling nut to 60 lb-ft (81 N•m). Do not
use air impact wrench (air gun), use an
accurately calibrated torque wrench such as
J 24406, or equivalent.
1. Install a new gasket on the air compressor
mounting flange.
2. Check to ensure that the lubrication oil
supply tube (2) is in place and position the
air compressor (1) on the mounting flange.
If the oil supply tube is lost, the air compressor
will fail from lack of oil.
3. Install the three mounting capscrews (5) and
tighten to the specified torque, 70 lb-ft
(95 N•m), using torque wrench J 24407, or
equivalent.
4. Reconnect the coolant lines to the air
compressor cylinder head.
295
Figure 295 — Air Compressor Installation
1. Air Compressor
2. Oil Supply Tube
3. Auxiliary Shaft
4. Oil Drain Openings
5. Capscrew
5_106_00.bk Page 267 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs