REPAIR INSTRUCTIONS
Page 285
17. Install the retaining capscrews to the
radiator support rods.
18. Position the fan clutch air solenoid valve, if
so equipped, on the radiator support and
install the retaining fastener.
19. Locate the engine coolant temperature
sensor, if applicable, and connect it to the
wiring harness. Fasten the sensor harness
to the radiator support.
20. Connect the chassis-mounted charge air
cooler (CMCAC) outlet hose at the cooler.
21. Connect the CMCAC inlet hose at the
cooler.
22. Place the coolant overflow tank in position
and install the retaining clamps.
23. Connect the lower radiator hose to the
coolant inlet of the oil cooler assembly.
24. Connect the upper radiator hose to the
coolant outlet fitting on the engine.
25. If the vehicle is equipped with air
conditioning:
a.
Connect the A/C refrigerant low-
pressure cutout switch to the wiring
harness connector.
b.
Connect the binary (cycling clutch)
pressure switch on the receiver/dryer to
the wiring harness connector.
c.
Connect the A/C line at the receiver/
dryer.
d.
Connect the A/C compressor discharge
hose to the system at the connection
point near the radiator support.
e.
Recharge the A/C system with
refrigerant using refrigerant recovery
and recycling equipment (J 38750-A for
R12 or J 39500-B for R134A).
26. Place the air intake tube in position and
tighten the clamps securing the intake tube
to the turbocharger and air filter.
27. Install the hood. Refer to the Hood
Installation procedures in the appropriate
vehicle manual.
5_106repair.fm Page 285 Monday, August 7, 2000 2:04 PM
BDC for engine manuals and specs