![background image](http://html1.mh-extra.com/html/mack/e-tech-sb-210-034/e-tech-sb-210-034_service-manual_3224387202.webp)
Page 186
REPAIR INSTRUCTIONS
GROOVE CUTTING PROCEDURE
1. Place the cutter base on the cylinder head.
Insert the hold-down capscrews into the
appropriate mounting holes (per application)
until the hold-down capscrews bottom out in
the mounting holes. Refer to Figure 181.
181
Figure 181 — Cutter Base Alignment
2. Position the cylinder head so the threaded
section of the hold-down capscrews can be
reached as shown in Figure 182. Install the
spacer, washer and wing nut. Lightly tighten
the wing nut.
The cutter base must be free to move.
182
Figure 182 — Fastening Cutter Base
3. Place the alignment fixture over the cutter
base as shown in Figure 183 to ensure
proper positioning. With the fixture in place,
tighten wing nuts on the hold-down
capscrews. Remove the alignment fixture.
1. Cutter Base
2. Cylinder Head
1. Wing Nut
2. Washer
3. Spacer
5_106_00.bk Page 186 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs